• Worldwide shipping
  • Chip tuning and vehicle diagnostic equipment

BitBox Plugin VAG Marelli Petrol

  • $112.67

This software module is for Magneti Marelli ECUs of petrol …

This software module is for Magneti Marelli ECUs of petrol VAG cars including Audi, Seat, Skoda, VW.

Magneti Marelli IAW 7GV

Based on Infineon SAK-XC2785X-104F80L with internal flash memory of 832KB.

These ECUs were used on cars with 1.4L and 1.6L engines (CFNA, CFNB, CLRA, CLPA, CLPB, CLSA, CGGB).

The module supports reading of flash memory and writing of calibration area over OBD with checksum calculation. Writing usually takes about 3 minutes.

The module BitEdit Marelli IAW 7GV can be used for remapping.

Magneti Marelli IAW 7GVE

Based on Infineon Infineon SAK-XC2xxx with internal flash memory of 832KB.

The module supports reading of flash memory and writing of calibration area over OBD.

Supported engines: 1.4L (CGGB).

Magneti Marelli IAW 9GV

Based on NXP SPC5634 with internal flash memory of 1.5MB.

These ECUs were used on cars with 1.4L and 1.6L biofuel engines (CFZA).

The module can read and write flash memory in BSL mode with checksum calculation.

The work is performed on bench with direct connection to the ECU.

Attention! Marelli 9GV is compatible with a limited set of J2534 cables. The following are successfully tested at the moment: CarDAQ Plus, Bosch VCM2, Mongoose.

The module BitEdit Marelli IAW 9GV can be used for remapping.

Magneti Marelli IAW 4HV

Based on ST10F296 with internal address space of 832KB.

These ECUs can be found on VAG cars with 1.4L petrol engines (BUD, BXW, CGGA, CGGB).

The module supports reading of flash memory and writing of calibration area via OBD over K-Line with checksum calculation.

Popular
BitBox Software (USB Dongle)