BitEdit Plugin Bosch ME17.8.8

A module for the BitEdit calibration software to work with files of Bosch ME17.8.8 and ME17.8.8.1 ECUs of Chinese vehicles with naturally aspirated and turbocharged petrol engines.

Available Maps

• Air control: airmass flow through throttle valve, throttle valve position, accelerator pedal map
• Boost: wastegate duty cycle target/linearisation, P-controller, regulation basis, boost limitations
• Exhaust gas temperature
• Idle: desired idle speed AT/MT, desired idle speed with A/C, minimal idle speed
• Knock control: knock sensor sensitivity per cylinder, retardation step, retardation recovery
• Limiters: engine speed limitation
• Spark advance: base spark advance, minimal spark advance, optimal spark advance, spark advance correction from lambda
• Switch operation modes: requested torque threshold to enter full load, throttle position for full load detection
• Target lambda: target lambda at part load, full load, acceleration, warm up, delay before entering acceleration, delta correction
• Torque limitation: monitoring torque limitation, offset tolerance for allowed torque, maximal torque
• Torque model: driver requested torque, optimal indicated torque, target air filling from torque, ignition angle efficiency, indicated torque limitation, lambda efficiency, minimal efficiency
• VVT: intake camshaft position
• Fan control: switching on/off coolant
• Injector control: injection end timing
• DTC mask editor

Supported SW

Technical Support

The technical support is provided by the manufacturer of this software.

Manufacturer

BitSoft LLC, St. Petersburg, Russia. License Agreement.