BitEdit Plugin Bosch MD1

A module for the BitEdit calibration software to work with files of Bosch MD1 ECUs of BMW vehicles with diesel engines. Supported file size: 7.5MB.

Available Maps

This module offers all necessary maps for chip tuning and EGR / DPF / SCR (AdBlue) removal. DTC table is also available.

• Air control: desired airmass, airmass correction
• Boost pressure: desired boost pressure, boost pressure limitation by atmospheric pressure, boost controller duty cycle with limitations
• DPF: DPF regenerations masks, DPF switch, exhaust pressure sensor flags, scalings, error voltage thresholds
• EGR Control: EGR position corrections, lower/upper thresholds for enable EGR for all modes, maximal EGR position request
• EGT sensors: all EGT sensors scalings, flags and error voltage thresholds
• Injection: injector opening time, injection quantity from torque, post injection quantities, start of main injection angle, start of injection limiters
• Rail pressure: PID-controller components, target rail pressure, rail pressure limitation, minimal rail pressure for start, rail pressure regulator
• SCR (ADBlue): Catalyst load/unload factors, switches for NOx, AdBlue injection, lambda regulation, NSC, LamCtl
• Target lambda: Target lambda for smoke limitation
• Torque limitation: main inner and outer torque limiters, torque limitation in system errors, torque limitation by EGT, exhaust pressure, fuel temperature
• Requested torque: requested torque, accelerator pedal maps for ECO, Sport, Sport+ modes, requested torque reducing by ECT and atmospheric pressure
• DTC mask

Supported SW

Technical Support

The technical support is provided by the manufacturer of this software.

Manufacturer

BitSoft LLC, St. Petersburg, Russia. License Agreement.